s
Fast-Trac Aluminum Cantilever Gate System
Fast-Trac Aluminum Cantilever Gate Specifications
FENCE GATES A.
Aluminum Cantilever Slide Gates
1. Gate Frames: Shall be fabricated in accordance with ASTM F 1184, Class 2. Vertical
frame
members shall be 2 inch square aluminum, with a .125" wall thickness and weighing 1.1 lbs./ft.
Bottom frame member shall be 2 inch x 4 inch aluminum, with a .125" wall thickness and
weighing 1.7 lbs./ft. Top track/frame member shall be a one-piece aluminum extrusion, weighing a minimum of 4.6 lbs./ft. Aluminum alloy used shall be 6061-T6 only. Intermediate uprights shall be 2
-inch square aluminum spaced equally at no more than 7 feet o.c. subdividing the gate frame into panels. All members shall be welded to form a rigid one-piece gate frame unit.
2.Fabric Filler: Shall match fence and be attached to the frame by means of hook bolts. Fabric shall be attached between each internal upright with hook bolts spaced no more than 15 inches o.c. as recommended by the manufacturer.
3.Trussing: Each bay shall be cross-trussed by means of 1/4" cable and adjustable turnbuckles bolted to corner gussets. Cable trussing will maintain the structural integrity of the gate while allowing for expansion and contraction o
f aluminum during various weather conditions.
4. Truck Assemblies: Shall be swivel type, zinc die cast, withsix (6)
factory sealed and lubricated ball bearing rollers. Four vertical rollers shall be 2 inches in diameter x 9/16-inch in width and two ball-bearing zinc plated steel side rollers to prevent lateral movement. Truck assemblies shall be mounted on post brackets using 7/8- inch diameter Clevis bolts with a 9/16-inch shank.
5. Bottom Guide Wheel Assemblies: Two 3 inch diameter rubber wheels (one set) st
raddling the bottom horizontal gate rail shall be installed, one set on the gate post and one on the overhang post.
6. Stop Bracket / End Plug: After gate has been installed, both ends of the combination
track/frame member shall be closed off with a shock-absorbing block bolted through the frame. The bottom 2" x 4" horizontal rail shall also have both ends completely closed with aluminum plate that has been continuously welded into place at the factory.
7.Hardware: Gate hangers, latches, brackets, guide assemblies and stops shall be steel,
galvanized after fabrication. A positive latch device shall be provided with provisions for
padlocking.
8.Posts: Gate posts, latch posts and overhang posts shall be 4 inches O.D. Schedule 40
galvanized pipe set in 12 inches x36 inches deep footings or as recommended by the
manufacturer. Concrete shall be troweled and sloped to shed water away from the posts.
9.Style: Style of gate frame shall be single, back-to-back or box frame, dictated by size of openingas recommended by manufacturer.
10.Certification: Mill certificates verifying that the 6061-T6 alloy has been used and that all othercomponents of this specification have been met are required
Single Gates Double Gates
Single
Up to 30 feet wide
Up to 60 feet wide
single gate
Back-to-Back
Up to 40 feet wide
Up to 80 feet wide
back-to-back gate
Single Back-To-Back Box 
Box Frame
Up to 60 feet wide
Up to 120 feet wide
box frame gate
fast trac III cantilever